ICOM IC 7800 INTERFACE SERIAL

Check the W10 device manager to find out what com port the device has made for itself and then you are away. Hook up the cables to your soundcard line-in/line-out connect the din cable to the appropriate din out on your Icom (or Yaesu) plug in your paddles/pump and, finally, connect the USB to your PC. This is the most reliable and simple-to-use interface I have used in over 20 years of sound-card digimode activity. Any required drivers were automatically installed by Windows 10. Once IвЂ™d worked out what leads went where it immediately began doing what it needed to. I found a used U5 Link on eBay for a very good price (ВЈ15/$20).

ICOM IC 7800 INTERFACE SERIAL

вЂ“ 1 x Serial Port DB9 Type CAT Cable (depends on radio type) вЂ“ WSJT JTDX HRD DM780 LOGG32NIMM WriteLog ECHOLINK easyPal SSTV Cw_player APRS AGWTracker MMTTY MMVARI MIXW etc. вЂ“ YAESU: FT450, FT950, Compatible with RS232-CAT port вЂ“ FT-450D HRD set: rate 4800, leave RTS DTR both blank, radio using VFO-A. вЂ“ Remote Interface standardization CAT: CAT (MINI DIN 8). вЂ“ Standardized voice / data radio interfaces: DATA (MINI DIN 6).

вЂ“ Plug and play, external power supply not required. вЂ“ Special customized high-quality audio isolation transformers, shielded isolation. вЂ“ Complete signal support: Contains TXD RXD RTS DTR CTS signals. вЂ“ Radio remote control interface support: full optical isolation, CAT remote support stable high-speed communications 115200 вЂ“ Support mechanisms refined data cable to connect the cable, plug and play вЂ“ Original 6N137 optocoupler high-speed communications, communication rates up to 115200.

Icom ic-7800 interface